Dell PERC 4/im - Manual (Page 18)

Volume if an IM volume is present on the monitored system.
The Status field describes the status of the IM volume and has 2 options: "Ok" or "Unknown." "Ok"
indicates either that the IM volume is completely operational. The "Unknown" option indicates that
there is problem with the IM volume that the CIM Browser cannot identify.
The "Redundancy Status" field describes the status of the IM volume redundancy and has three
options: "Fully Redundant", "In Degraded Mode", or "Redundancy Is Lost." "Fully Redundant" indicates
that the IM volume is functioning properly and that the data is fully redundant. "In Degraded Mode"
indicates that the IM volume is running in a degraded mode. A possible cause of this mode is the
failure of a single disk. "Redundancy is Lost" indicates that the redundant data is lost. A possible
cause of this mode is the failure of both disks.
The "Additional Redundancy Information" field options are "Resynch in progress" or "Resynch not in
progress." When the resynchronization is in progress, the CIM Browser displays a status bar giving
the approximate percent completion and an estimate of the time until completion.
Physical
Disk This level provides information on the physical disks in the system. Physical disks have a "Physical
Disk State" field that provides information concerning the status of the physical disk.
Storage
Device This field provides information on the storage device.
Linux Installation Instructions for the CIM Solution
This section describes a Linux installation for version 3.03.00 of the CIM solution.
Installing the CIM Solution
Follow these steps to install the CIM solution:
1. Unzip the CIM package after downloading it.
2. Double click on the "install.htm" program that you downloaded from the LSI Logic website.
A "Security Warning" window appears. You must grant additional privileges to the InstallAnywhere to
complete the installation.
3. Click on "Yes."
4. Click on "Start Installer for Linux..."
The InstallAnywhere begins.
5. Follow the instructions and steps in InstallAnywhere.
If this button does not appear in the browser, launch a terminal window and type "./install.bin" from the directory that
accesses the CDROM.
To verify the installation for the CIM Browser, launch the application from /usr/local/bin/LSICim prompt by typing:
./CIMLSIBrowser
Uninstalling the CIM Solution
To uninstall the CIM solution, follow these steps:
Exit the CIM Browser.
Change the directory by typing
cd /usr/local/bin/LSICim/UninstallerData
At the command prompt type.