Dell PowerEdge 6850 - Manual (Page 2)

www
.dell.com | support.dell.com
3 Install the north bridge heat sink:
a Orient the heat sink so that its alignment key is toward the back of the system board. See
Figure 1.
b Slowly lower the end of the heat sink closest to processor connectors 2 and 4 into the
heat-sink bracket.
c After the heat sink contacts the bottom of the heat-sink bracket, align the keys on the
heat sink and the heat-sink bracket, then lower the heat sink until it lays flat in the
bracket. See Figure 1.
d Lower the retention clip, compress the two retention-clip tabs together, and secure the
tabs into the retention-clip securing slots.
Figure 1. Removing and Installing the North Bridge Heat Sink
____________________
Information in this document is subject to change without notice.
© 2005 Dell Inc. All rights reserved. Printed in the U.S.A.
Reproduction in any manner whatsoever without the written permission of Dell Inc. is strictly forbidden.
Trademarks used in this text: Dell and the DELL logo are trademarks of Dell Inc.
Other trademarks and trade names may be used in this document to refer to either the entities claiming the marks and names
or their products. Dell Inc. disclaims any proprietary interest in trademarks and trade names other than its own.
north bridge heat sink
retention-clip
tabs (2)
retention-clip
securing slots (2)
heat-sink bracket
heat-sink alignment key
heat-sink bracket alignment key