Dell Inspiron 14 (N4020, Early 2010) - Manual (Page 20)

10. Remove the four screws (two on each side) that secure the display-panel brackets to the display panel.
Replacing the Display Panel
1. Follow the instructions in Before You Begin .
2. Replace the four screws (two on each side) that secure the display-panel brackets to the display panel.
3. Adhere the camera cable at the back of the display panel.
4. Connect the display cable to the display-board connector and secure it with the tape.
5. Align the screw holes on the display panel with the screw holes on the display cover and replace the six screws.
6. Connect the camera cable to the connector on the camera module.
7. Replace the display bezel (see Replacing the Display Bezel ).
8. Replace the display assembly (see Replacing the Display Assembly ).
Back to Contents Page
1 display cable 2 back of the display
panel
3 display-board
connector
4 tape
1 screws (4) 2 display-panel brackets (2)
CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.