Serial port connectors, Parallel port connector – Dell PowerEdge 4600 User Manual

Page 5

Advertising

Both the new and the remapped COM ports share the same interrupt request (IRQ) setting, as follows:

COM1, COM3: IRQ4 (shared setting)
COM2, COM4: IRQ3 (shared setting)

These COM ports have the following I/O address settings:

COM1: 3F8h
COM2: 2F8h
COM3: 3E8h
COM4: 2E8h

For example, if you add an internal modem card with a port configured as COM1, the system then sees logical COM1 as the address on the modem card. It
automatically remaps the integrated serial port that was designated as COM1 to COM3, which shares the COM1 IRQ setting. (Note that when you have two
COM ports sharing an IRQ setting, you can use either port as necessary but you may not be able to use them both at the same time.) If you install one or
more expansion cards with serial ports designated as COM1 and COM3, the corresponding integrated serial port is disabled.

Before adding a card that remaps the COM ports, check the documentation that accompanied your software to make sure that the software can be mapped to
the new COM port designation.

To avoid autoconfiguration, you may be able to reset jumpers on the expansion card so that the card's port designation changes to the next available COM
number, leaving the designation for the integrated port as is. Alternatively, you can disable the integrated ports through the System Setup program. The
documentation for your expansion card should provide the card's default I/O address and allowable IRQ settings. It should also provide instructions for
readdressing the port and changing the IRQ setting, if necessary.

If you

add an expansion card containing, for example, a parallel port configured as LPT1 (IRQ7, I/O address 378h), you must go into the System Setup

program to remap the integrated parallel port.

For general information on how your operating system handles serial and parallel ports, and for more detailed command procedures, see your operating
system documentation.

Serial Port Connectors

If you reconfigure your hardware, you may need pin number and signal information for the serial port connectors.

Figure B

-2

illustrates the pin numbers for the

serial port connectors and

Table B

-1

defines the pin assignments and interface signals for the serial port connector.

Figure B-2. Pin Numbers for the Serial Port Connectors

Parallel Port Connector

If you reconfigure your hardware, you may need pin number and signal information for the parallel port connector.