Dell Inspiron 15R (5537, Mid 2013) - Manual (Page 37)

Replacing the System Board | 37
Replacing the System Board
WARNING: Before working inside your computer, read the safety information
that shipped with your computer and follow the steps in "Before You Begin" on
page 7. After working inside your computer, follow the instructions in "After
Working Inside Your Computer" on page 9. For additional safety best
practices information, see the Regulatory Compliance Homepage at
dell.com/regulatory_compliance.
NOTE: Your computer’s Service Tag is stored in the system board. You must enter
the Service Tag in the system setup after you replace the system board.
Procedure
1 Align the screw hole on the system board with the screw hole on the
computer base.
2 Replace the screw that secures the system board to the computer base.
3 Connect the power-adapter-port cable, speaker cable, and the I/O board cable to
the connectors on the system board.
4 Connect the display cable to the system board.
5 Adhere the tape that secures the display cable to the system board.
Postrequisites
1 Replace the wireless mini-card. See "Replacing the Wireless Mini-Card" on page 30.
2 Replace the palm-rest. See "Replacing the Palm-Rest" on page 27.
3 Replace the keyboard. See "Replacing the Keyboard" on page 23.
4 Replace the optical-drive assembly. See "Replacing the Optical-Drive Assembly" on
page 17.
5 Replace the hard-drive assembly. See "Replacing the Hard-Drive Assembly" on
page 20.
6 Follow the instructions from step 3 and step 4 in "Replacing the Memory Module(s)"
on page 14.
7 Replace the battery. See "Replacing the Battery" on page 11.
Entering the Service Tag in system setup
1 Turn on the computer.
2 Press <F2> during POST to enter system setup.
3 Navigate to the Main tab and enter your computer’s Service Tag in the
Service Tag Input field.
OM_Book.book Page 37 Thursday, May 9, 2013 1:34 PM