Dell Alienware M17x R4 (Early 2012) - Manual (Page 28)

28 | Replacing the Graphics-Card Heat Sink Fan
Replacing the Graphics-Card
Heat Sink Fan
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
"Before You Begin" on page 9. For additional safety best practices
information, see the Regulatory Compliance Homepage at dell.com/
regulatory_compliance.
Procedure
1 Align the screw holes on the graphics-card heat sink fan with the screw holes on the
chassis.
2 Tighten the captive screws that secure the graphics-card heat sink fan to the
chassis.
3 Connect the graphics-card heat sink fan cable to the connector on the system board.
Postrequsites
1 Replace the compartment door. See "Replacing the Compartment Door" on page 15.
2 Replace the battery pack. See "Replacing the Battery Pack" on page 13.
3 Follow the instructions in "After Working Inside Your Computer" on page 11.
14