Power supply, Removing the power supply, Replacing the power supply – Dell OptiPlex XE (Early 2010) User Manual
Page 34
Back to Contents Page
Power Supply
Dell™ OptiPlex™ XE Service Manual—
Small Form Factor
Removing the Power Supply
1.
Follow the procedures in
Before Working Inside Your Computer
.
2.
Remove the
optical drive
.
3.
Remove the
hard drive
.
4.
Remove the
back thermal sensor
.
5.
Remove the
fan
.
6.
Disconnect the power cables from the system board.
7.
Pull up the power supply release latch and slide the power supply toward the front of the computer.
8.
Remove the power supply from the computer.
Replacing the Power Supply
To replace the power supply, perform the above steps in reverse order.
Back to Contents Page
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTE:
You may need to install Adobe® Flash® Player from Adobe.com in order to view the illustrations below.