Dell PowerVault 132T LTO/SDLT (Tape Library) User Manual
Page 14
12
Dell PowerVault DLT, VS, and SDLT Media Handbook Version 2.0
www
.dell.com | support.dell.com
Cartridge Inspection
•
Case: Inspect the case for cracks, chips, or signs of damage.
•
Cartridge: Inspect the exterior of the cartridge for chips, cracks, dents, or missing screws.
Gently shake the cartridge. Listen for rattling or loose pieces.
•
Cartridge Door: Ensure that the door is moveable and that the spring is present.
•
Write Protect Switch: Move the switch. It should snap into write-protected mode and write-
enabled mode.
•
Cartridge Leader: Gently inspect the cartridge leader to verify that it has not been damaged
and is in the correct position.
•
DLTtape Cartridges: Check the height of the leader to ensure that the loop is sticking up
approximately 3/16 inch or 4 mm. Ensure that the door operates. DLT tape leader loop
should be visible and undamaged.
•
Super DLTtape Cartridges: Check that the Super DLTtape leader buckle aligns with
cartridge edge and metal pin is not bent.
NOTE:
When inspecting the cartridge leader do not use anything that could leave contamination,
such as a pen or pencil.
Figure 1-18.
DLTtape Leader Loop