Dell OptiPlex E1 - Manual (Page 34)

2-4 Dell OptiPlex E1 Managed PC Service Manual
 'XULQJ WKH ERRW URXWLQH REVHUYH WKH V\VWHP IRU DQ\ RI WKH
IROORZLQJ
‡
Diskette-drive and hard-disk drive access indicators: These indicators
light up in response to data being transferred to or from the drives. If
either of these indicators fails to light up during the boot routine, trou-
bleshoot the diskette drive or hard-disk drive subsystem, as
appropriate.
‡
System error messages: These messages can indicate problems or
provide status information. If a system error message is displayed, see
Table 3-2.
‡
Beep codes: A beep code is a series of beeps that indicates an error
condition. If the system emits a beep code, see Table 3-1.
 2EVHUYH WKH PRQLWRU VFUHHQ IRU WKH 'LDJQRVWLFV 0HQX
Does the Diagnostics Menu appear?
Yes. See “Running the System Diagnostics” found later in this chapter.
No. Proceed to step 6.
 ,QVHUW DQRWKHU FRS\ RI WKH 'HOO 'LDJQRVWLFV 'LVNHWWH LQWR WKH GLV
NHWWH GULYH DQG UHERRW WKH V\VWHP
Does the Diagnostics Menu appear?
Yes. See “Running the System Diagnostics” found later in this chapter.
No. Proceed to the next section, “Internal Visual Inspection.”
,QWHUQDO9LVXDO,QVSHFWLRQ
&$87,21 %HIRUH \RX SURFHHG ZLWK WKH LQWHUQDO YLVXDO LQVSHFWLRQ
GHVFULEHG LQ WKLV VHFWLRQ HQVXUH WKDW WKH XVHU KDV VDYHG DOO RSHQ
ILOHV DQG H[LWHG DOO RSHQ DSSOLFDWLRQV LI SRVVLEOH
A simple visual inspection of a computer’s interior hardware can often lead to
the source of a problem, such as a loose expansion card, cable connector, or
mounting screw. When you perform the visual inspection, refer to Figures 1-3
through 1-6 as appropriate for your system for component location information.
To perform the internal visual inspection, follow these steps:
 7XUQ RII WKH V\VWHP LQFOXGLQJ DQ\ DWWDFKHG SHULSKHUDOV DQG GLV
FRQQHFW DOO WKH $& SRZHU FDEOHV IURP WKHLU SRZHU VRXUFHV
 5HPRYH WKH FRPSXWHU FRYHU