Media card reader, Removing a media card reader – Dell Dimension E521 User Manual
Page 33
11.
Connect your computer and devices to their electrical outlets, and then turn them on.
See the documentation that came with the drive for instructions on installing any software required for drive operation.
12.
Enter system setup (see
System Setup
) and select the appropriate Diskette Drive option.
13.
Verify that your computer works correctly by running the Dell Diagnostics (see
Dell Diagnostics
).
Media Card Reader
Removing a Media Card Reader
1.
Follow the procedures in
Before You Begin
.
2.
Remove the computer cover (see
).
3.
Remove the drive panel (see
).
4.
Disconnect the USB cable from the back of the Media Card Reader. Disconnect the other end of the cable from the USB connector on the system board
(see
System Board Components
). Remove the cable from any clips and lift out of the computer.
NOTICE:
To connect a network cable, first plug the cable into the network device and then plug it into the computer.
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
CAUTION:
To guard against electrical shock, always unplug your computer from the electrical outlet before removing the cover.
NOTICE:
To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your
computer's electronic components. You can do so by touching an unpainted metal surface on the computer chassis.
1
Media Card Reader (optional)
2
cable
3
USB connector