Display bezel, Replacing the display assembly, Removing the display bezel – Dell Inspiron 15 (N5030, Mid 2010) User Manual
Page 15
Replacing the Display Assembly
1.
Follow the instructions in
Before You Begin
.
2.
Place the display assembly in position and replace the two screws (one on each side) that secure the display assembly to the computer base.
3.
Route the display cable into the routing guide and connect the display cable to the connector on the system board.
4.
Route the Mini-Card antenna cable into the routing guide and connect the Mini-Card antenna cable to the connector on the Mini-Card.
5.
Turn the computer over and replace the two screws at the base of the computer.
6.
Replace the palm rest (see
Replacing the Palm Rest
).
7.
Replace the keyboard (see
Replacing the Keyboard
).
8.
Replace the battery (see
Replacing the Battery
).
Display Bezel
Removing the Display Bezel
1.
Follow the instructions in
Before You Begin
.
2.
Remove the display assembly (see
).
3.
Using your fingertips, carefully pry up the inside edge of the display bezel.
4.
Remove the display bezel.
1
display assembly
2
screws (2)
3
display cable
4
Mini-Card antenna cable
CAUTION:
Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.
CAUTION:
The display bezel is extremely fragile. Be careful when removing it to prevent damaging the bezel.