Dell PowerVault 124T - Manual (Page 30)

To configure the Dell PowerVault 124T LTO6 SAS autoloader, you must verify the setup of the following:
Magazine(s).
Ethernet IP address (if you are not using DHCP).
SNMP server IP address—only if SNMP is being used.
Time server IP address (or the time zone, date, and time, if configuring manually)—only if a time server
is being used.
Control mode.
Security option.
Setting Ethernet
Ethernet is the method used by the autoloader to access a network. With an Ethernet connection, you can
remotely access the autoloader over the network. To use the Ethernet connection, you must define the
following:
A dynamic or static IP address for the autoloader (required)
A subnet mask (required for static IP), not required for IPv6
An IP gateway (optional)
A Simple Network Management Protocol (SNMP) server (optional)