CLIFFORD GP500 - Manual (Page 20)

How to en ter your PIN Code for the first time
The PIN code provides two functions: to turn the alarm off in the event that
you cannot use your remote control and secondly, to access programming
mode. Your GP500 PIN code was set by the factory. You may want to
change the PIN code using the instructions provided to insure the utmost
vehicle security.
EX AM PLE: To en ter the factory preset Pin code of 2, you
would press and re lease the PlainView 2 switch
but tons thusly: ✱✱ marked, un marked.
How to set your PIN code
You may choose any 1-, 2-, 3- or 4-digit code, but the first digit must not be a
zero (e.g., 1023 is a valid code, 0123 would not be a valid code).
NOTE: You may NOT se lect a code that be gins with a
zero. The first digit of your code must be 1–9.
Ex am ple
To set a disarming code of 4301, you would do the following:
1. Enter program mode by turning on the ignition, entering your current
PIN code, then pressing and holding the PlainView 2 ✱ button for 3 seconds
until you hear a chirp.
18 GP500