Casio ID-15 - Manual

Operation Guide ID-15
1
MA0505-EA
1cm
ALM/SNZ INVALID
INVALID
ON
OFF
RESET SET °C/°F
SNZ
ALM/SNZ INVALID
INVALID
ON
OFF
RESET SET °C/°F
SNZ
ALM/SNZ INVALID
INVALID
ON
OFF RESET SET °C/°F
SNZ
ALM/SNZ INVALID
INVALID
ON OFF RESET SET °C/°F
SNZ
• A sticker is affixed to the glass of the clock when you purchase it. Be sure to remove the sticker before using the
clock.
• Depending on the clock model, its configuration may differ somewhat from that shown in the illustration.
Current time
(Hour, minutes,
seconds)
Day of the week Current temperature
Date
(month - day)
PM
indicator
Alarm time
Snooze on
indicator
Alarm on indicator
Alarm Off Snooze Alarm On
ILLUSTRATION GENERAL GUIDE
1 1 1 1 1 ALM/SNZ button
• Pressing this button while the alarm is sounding stops the alarm.
2 2 2 2 2 Alarm Mode selector
SNZ: Snooze alarm on
ON: Alarm on
OFF: Alarm off
3 3 3 3 3 + / – buttons
Use these buttons to change the alarm time or the setting that is flashing on the display.
4 4 4 4 4 ° C/ ° F button
Press this button to toggle the temperature units between Celsius and Fahrenheit.
5 5 5 5 5 SET button
Use this button when setting the current time.
6 6 6 6 6 RESET button
Press this button to reset the clock after replacing its batteries.
• Buttons marked “INVALID” have no function.
USING THE CLOCK
1. Press the SET button (5) to cycle through the setting screens as shown below.
12-hour/24-hour
Timekeeping Screen
Time Setting Screen Month and Day
Setting Screen
Year Setting Screen
Normal Timekeeping Screen
2. While the screen you want is displayed, use the + and
– buttons (3) to change the flashing digits.
• Holding down + or – changes the flashing digits at high
speed.
• You can set the year in the range of 2000 to 2039. The
day of the week is set automatically in accordance with
the date setting.
• Pressing + or – while the Time Setting Screen is on the
display causes the seconds count to be reset to 00.
• Each press of + or – while the 12-hour/24-hour
Timekeeping Screen is on the display toggles between
12-hour and 24-hour timekeeping.
3. After making the settings you want, use the SET button (5) to display the Normal Timekeeping Screen.
• The clock automatically returns to the Normal Timekeeping Screen if you leave a setting screen on the display for
about three minutes without performing any operation.
ALM/SNZ INVALID
INVALID
ON
OFF RESET SET °C/°F
SNZ
Press – to
decrease
the flashing
digits. Press + to
increase
the flashing
digits.