Local management, 1 overview, Chapter 5 – Cabletron Systems 6H122-16 User Manual
Page 41: Overview -1, Er to, Chapter 5 local management
6H122-16 User’s Guide
5-1
CHAPTER 5
LOCAL MANAGEMENT
This chapter explains how to set up a management terminal to access
6H122-16 Local Management. It also explains how to use the Local
Management screens and commands.
5.1
OVERVIEW
Local Management for the 6H122-16 consists of a series of management
screens that allows management of the module, the attached segments,
and the 6C105 chassis. The management screens allow the following
tasks to be performed:
•
Manage any interface module in the chassis via a connection to a
single interface module.
•
Assign IP addresses and subnet masks to the 6H122-16 module, and
the 6C105 chassis.
•
Control access to the 6H122-16 module and the 6C105 chassis by
establishing community names.
•
Download a new image of operating software.
•
Designate which Network Management workstations receive SNMP
traps from the 6H122-16 module and the 6C105 chassis.
•
Monitor the environmental status of the 6C105 chassis.
•
View switch, interface, and RMON statistics.
•
Assign ports to operate in standard or full duplex mode.
•
Enable trunking of ports to perform load sharing.
There are three ways to access Local Management:
•
Locally using a VT type terminal connected to the COM port of the
6H122-16.
•
Remotely using a VT type terminal connected through a modem.
•
In-band through a Telnet connection.