Dell PowerVault 56F (16P Fibre Channel Switch) - Manual (Page 19)

Rack Installation Guide 1-3

  &
'
  
You may remove the front and back doors from the rack to provide access to the
interior of the rack and to prevent damage to the doors while installing the kit. Use
the following procedure to remove the doors.
 
   
#  
! 

"       
1. Open the latch on the front door (see Figure 1-2).
Slide the latch’s push-button cover up as far as it will go, press the push button,
rotate the handle clockwise until the latch releases, and then pull the door open.

 
 

2. Remove the front door (see Figure 1-3):
a. One person should grasp the top of the door to stabilize it. The other person
should grasp the bottom of the door.
b. The person holding the bottom of the door should press the hinge release
lever on the bottom hinge and then pull the bottom of the door away from
the rack a few inches.
c. The person holding the top of the door should press the hinge release lever
on the top hinge and then pull the door away from the rack.
3. Repeat steps 1 and 2 to remove the back door from the rack.
push button
push-button
cover
handle
4939tbk1.book Page 3 Friday, October 8, 1999 1:22 PM