Installation, Site preparation, Unpacking the switch – Dell PowerEdge M605 User Manual
Page 7
Getting Started Guide
5
Installation
This document provides basic information to install, configure, and operate Dell™ PowerConnect™
M6220 systems. For more information, see the
Hardware Owner’s Manual, which is available on
your
User Documentation CD, or check the Dell Support web site at support.dell.com for the latest
updates on documentation and firmware.
Site Preparation
Before installing the switch, make sure that the chosen installation location meets the site
requirements specified in the Hardware Owner’s Manual.
Unpacking the Switch
Package Contents
When unpacking each switch, make sure that the following items are included:
•
One PowerConnect switch
•
One USB type A-to-DB9 serial cable
•
User Documentation CD
•
Getting Started Guide
•
Product Information Guide
Unpacking Steps
NOTE:
Before unpacking the switch, inspect the container and immediately report any evidence of damage.
1
Place the container on a clean, flat surface and cut all straps securing the container.
2
Open the container or remove the container top.
3
Carefully remove the switch from the container and place it on a secure and clean surface.
4
Remove all packing material.
5
Inspect the product and accessories for damage.
JR183.book Page 5 Thursday, June 7, 2007 2:40 PM