QHYCCD QHY5 - Manual (Page 7)

11 12
QHY5 SOFTWARE ABC COURSE
QGVideo5T is the capture software for QHY5.
It’s supports reading out non-compressed
video/image data, and it is very suit for
capturing solar, moon, or planets.
1. Run QGVideo5T, if the drivers of QHY5 has
been installed correctly, and QHY5 has been
connected with computer correctly, the
software will note “CONNECTED” and run, if
the QHY5 has been not installed correctly,
the software will note “No Camera Detected” .
2. Select Capture Files-Select Capture
Location，set the file saving location.
3. Select Capture Files-Select Base Filename,
set the file saving base filename.
4. Set the subframe size in the left of the
software.
5. Set the expose time and gain in the left
of the software. You can watch the realtime
image in the right of it.
6. Set Delay time. That is the time between
frame and frame. That time is used for
transferring image data, so it could not be
setted
to low. That is depend on the
computer.
7. Set capture count.
8. Set Dark Count. Using this function, the
software will capture a number of dark
frames at first, and capture the light
frames, after that, the software will use
the light frames to subtract dark frames.
9. Click the image will show the larger on
this area. It is convenient for focus.
10. Click the AVI button to start capture
the non-compressed video.