Samson DOUBLE BRAID Class II End-for-End Splice Modified for Turbo-37 - Manual (Page 2)

PAGE 2 OF 4
SamsonRope.com | Email [email protected] | Tel +1.360.384.4669
Double Braid Class II End-for-End Splice Modified for Turbo-37
S A M S O N S P L I C I N G I N S T R U C T I O N S
pulling top 3 and center
J o i n i n g t H e s u B - r o p e s
a r r a n g i n g B ot t o m 3 s u B - r o p e s
Pull the top 3 and center sub-ropes out
of the way on both sides (Fig. B).
Insert sub-rope 1 from the right into sub-rope 1 from the left by
tucking under 1 strand at the mark (Fig. D). Draw the right-hand
sub-rope through until the mark on it coincides with mark on the
left-hand sub-rope. (Fig. E) This is the 1st tuck.
Arrange bottom 3
sub-ropes from each
side as shown.
7
step
a r r a n g i n g s u B - r o p e s
Arrange sub-ropes in groups as shown,
separating the top 3, the center 1, and
the bottom 3 (Fig. A).
6
step
Figure B
Top 3
Center
Bottom 3
Unbraided
cover
Top 3
Figure a
Center
Bottom 3
Figure d
Pairing of bottom 3 sub-ropes (sub-ropes numbered 1 will be
spliced together, numbered 2 will be spliced together, etc.)
Note: After splicing bottom 3 and center 1, top 3 will be
paired likewise.
Figure c 1
1
2
2
3
3
Figure e
8
step
9
step
Fig. C shows how the bottom 3 strands from each side will be
paired. Note that the corresponding sub-ropes from each side
should have the same direction of twist.
Top 3
Top 3
Center
Center
Bottom 3
Bottom 3