Samson DOUBLE BRAID Class II End-for-End Splice Modified for Turbo-37 User Manual
Page 4
PAGE 4 OF 4
SamsonRope.com
| Tel
+1.360.384.4669
Double Braid Class II End-for-End Splice Modified for Turbo-37
S A M S O N S P L I C I N G I N S T R U C T I O N S
16
15
step
step
Wrap entire area with tape
3 tucks with cover
bundles
Splice crossover
3 tucks with cover
bundles
d i v i d i n g u n B r a i d e d c o v e r
g r o u p i n g a n d t u c k i n g c o v e r s
s e i Z i n g t H e c o v e r
g r o u p i n g a n d t u c k i n g c o v e r s
c o v e r i n g t H e s p l i c e a r e a
Place the rope under tension, then divide the unbraided cover material
(from Step 3) at each end of the splice into 6 equal bundles.
Tuck the cover bundles at each end of the splice. Starting at either end of the splice, take 1 of the 6 cover bundles, pass it
over 1 sub-rope and under the very next (forming a simple tuck similar to that used in splicing 3-strand rope.) Repeat until all
6 bundles have been tucked once. Then tightly tape around the rope at the point where the tucks occur. Repeat this process
until a minimum of 3 tucks have been made with all 6 bundles. After the last set of tucks, trim off the excess cover yarn. Now
repeat entire procedure, starting at the other end of the splice. With splice area still under tension, apply tape to entire area.
Milk all of the excess cover slack from the middle of the
cover material down towards both ends of line. Tightly
tape the cover to the rope approximately equal to rope
diameter (in inches) back from the end of the cover.
Unbraid the cover strands from the tape to the end.
Seize over the area for a distance of 2 times rope
diameter (in inches) with nylon seizing material.
After seizing both ends of the cover material, apply a two-part urethane coating over the seized areas as
shown, extending the urethane coating 1/2 the length of the seized area on both sides of the seizing.
Release tension and slide the section of cover on the rope in Step 2 into position over the splice with the splice
crossover at the center. Remove all slack from the cover by milking away from the crossover in each direction.
17
step
Slide cover material over exposed
cores. Installed in Step 2.
Cover material over spliced area
tape
18
step
19
step
2 x rope diameter (minimum)
Seized area
Coated area
Seized area
Coated area
DOCUMENT Double_Braid_C2_End_for_End_Turbo-37.pdf
© 2012 Samson Rope Technologies, Inc. All rights reserved.
S/WD #108294 7/2012