Scilogex SK-O180-Pro - Manual (Page 8)

6
SK-O（L）330- Pro Orbital and Linear Digital Shaker SK-O（L）180- Pro Orbital and Linear Digital Shaker
Note:
The current set speed can be varied at any time.
6.Operating modes
6.1 Mode A
Operating mode A is the default mode set in factory. After
turning ON the instrument with the mains switch, the
shaking and timing functions are turned OFF. The LCD
displays the set time and speed values. They are adopted or
varied when the corresponding functions are turned ON.
After turning ON the instrument, the following process will
be shown on the display.
• The left LCD displays “SAF” and the right displays the
upper speed limit( rpm）which can be set by pressing the
speed knob and turning at the same time.
Figure 3
• The LCD displays run modes “StA”、“A” or “B”
for about 2 seconds.
Figure 4
• The set or stored speed value is shown in the left display, and
the set or stored time value is shown in the right display. Turn
the speed knob and time knob can set the speed and time.
Figure 5
• After pressing the speed knob or time knob, the instrument
begins to run at the set speed. The actual speed and time
remaining are shown in the LCD. If the remaining has
reached zero, the shaker stops its motion. Pressing the
speed knob alone,the instrument will work at continuous
mode(The time function is OFF)
Figure 6
Note:
The set values can be varied during shaking.
Shaking can be stopped by pressing the left or
right knob.