Sony CPD-1304S - Manual (Page 4)

Location and Function of Controls
[T] POWER switch and indicator
To turn on the power of the unit, press this switch. The indicator will
light up. To turn off the unit, press it again.
[I] CONTRAST control (O)
Turn clockwise to increase contrast, or counterclockwise to decrease
contrast,
[3] BRIGHTNESS control (o)
Turn clockwise for a brighter display, or turn counterclockwise for a
darker display.
AC IN connector
Connect to an AC outlet with the supplied AC power cord.
To obtain the same horizontal and vertical sizes of 48 kHz or 57 kHz frequency
with those of VGA mode
Adjust the H SIZE and V SIZE while receiving 48 kHz or 57 kHz to the same sizes with
that ot VGA mode, and set the AUTO SIZE switch to LOCK i1 it is set to ADJ,
When the display receives the 48 kHz or 57 kHz frequency the next time, the horizontal
and vertical sizes become the same as those of VGA mode,
6
[g AUTO SIZE switch
Depending on the microcomputer connected to the display, set this
switch to the appropriate position.
LOCK: For the IBM PS/2 microcomputer using the VGA mode.
When this switch is set to LOCK, the timing is automatically
adjusted to the VGA mode, and the H SIZE, H SHIFT, V SIZE
and V CENT controls will have no effect.
ADJ: For other microcomputers having analog RGB output.
When this switch is set to ADJ. adjust the display with the H
■ SIZE. H SHIFT, V SIZE and V CENT controls.
• To adjust the horizontal frequencies of less than 40 kHz, set the
AUTO SIZE switch to ADJ.
• To adjust the horizontal frequencies of 40 kHz or more, set the
AUTO SIZE switch to either LOCK or ADJ.
11 ] H SIZE (horizontal size) control
Turn this control to adjust the horizontal size of the display.
Ul H SHIFT (horizontal shift) control
Turn this control to adjust the center of the display horizontally.
[il V CENT (vertical center) control
Turn this control to adjust the center of the display vertically.
H V SIZE (vertical size) control
Turn this control to adjust the vertical size of the display.