Connections, Connecting to outdoor antenna, Vhf/uhf – Sony KV-20S10 User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Setting Up
Connections
Select one of the three ways to connect the TV to the antenna and/or
cable system. It is recommended to cormect an outdoor anteima or a
cable TV system for better picture quality.
Connecting to outdoor antenna
Connect the antenna cable to the VHF-UHF antenna terminal. If the
antenna cable carmot be connected directly to the jack, follow one of the
diagrams below, depending on the type of cable you have.
Notes
• Do not use tools to attach the cable to the VHF/UHF terminal. Doing so may
damage the terminal.
• Most VHF/UHF combination antennas have a signal splitter. Remove the splitter
before attaching the appropriate connector.
• If the U/V mixer is used, snow and noise may appear in the picture when viewing
cable TV channels over 37.
□
(Rear of TV)
. VHP only
or
. VHF/UHF
VHF/UHF
“1
75-ohm coaxial cable
To attach an F-type connector, see "Attaching
an F-type connector to the antenna cable."
m
(Rear of TV)
• VHF only
or
• UHFonly
or
• VHF/UHF
Loosen the screws and
connect the leads, then
tighten.
Antenna connector (suppiied
except for KV-MT2000/ST2050)
300-ohm twin lead cable
(Rear of TV)
.VHF
and
. UHF
75-ohm coaxial cable
EAC-66 UV mixner
(not supplied)
300-ohm twin lead cable
Setting up
I