Sony CDX-65RF - Manual (Page 6)

Initial Settings
POWER SELECT Switch
The display on Ihe display unit is factory-set to
come on when the ignition key of your car is
turned on. However, this setting may cause
some car battery wear if used in a car which has
no ACC (accessory) position on the ignition key
panel. To avoid battery wear when used in
such a car, set the TOWER SELECT switch
Iwated on the side of the hideaway unit to the
OFF position*.
When the ignition key is turned off, the display
on the display unit will go off as welt. When
you change the setting of the TOWER SELECT
switch, be sure to press the reset button on the
display unit.
• When the IX^WER SELECT switch is set to the OFF
position, you will not be able to start CD play with
the remote commander while the system is in the off
mode, that is to say when there is no display on the
display unit. Therefore press the POWER switch on
the display unit before operating the remote
commander.
Changing the Ti-ansmitting
Frequency
You can select the frequency of the modulated
RF signal being transmitted from the hideaway
unit according to the level of interference noise.
1. Press the SEL button for approx. 2
seconds.
The system will enter the frequency selecting
mode. The initial setting is 88.3 MHz.
2. Press either the 6 or 6 button to select
the frequency.
At each pressing, the buttons will change the
frequency as follows;
Q : 88.3 MHz-»89.9 MHz-*89.7 MHz
-♦S8.7MH7 -*88.3 MHz
3. Press the SEL button again for approx. 2
seconds.
c to sot the froquor
wly selected frequt
Changing the Output Level
You can select the output level from the Cl)
changer unit. Normally the system is used in
the initial output level, change the level if
necessary.
1. Press the SEL button for approx. 2
seconds.
The system will enter the frequency selecting
mode
2. Press the SEL button again.
The system will enter the output level
selecting mode. The indication is as follows:
Initial setting
To decrease the output level
□ -► P'' --
U . .
To increase the output level
□ “*■ • • '■
3. Press the SEL button once again for
approx. 2 seconds.
10 11