Sony CDX-C660 - Manual (Page 4)

Getting Started
Resetting the unit
Before operating the unit for the first time or
after replacing the car battery, you must reset
the unit.
Press the reset button with a pointed object,
such as a bail-point pen.
□
Reset button
Notes
■ • Pressing the reset button will erase the clock and some
memorized functions.
• When you connect the power supply cord to the unit or
reset the unit, wait for about 10 seconds before you insert
a disc. If you insert a disc within these 10 seconds, the .
unit will not be reset, and you will have to press the reset
button again.
Detaching the front panel
You can detach the front panel of this unit to
prevent the unit from being stolen.
1
Press rOFF).
2 Press (RELEASE) to Open up the front
panel. Then slide the front panel a little
to the left, and pull it off towards you.
* Be sure not to drop the panel when detaching it from the_
unit.
* If you press ( RELEASE) to detach the panel while the
unit is still on, the unit will turn off automatically to
prevent the speakers from being damaged.
* When you carry the front panel with you, put it in the
supplied front panel case.
Attaching the front panel
Align part ® of the front panel to part ® of
the unit as illustrated, and push until it clicks.
Notes
• Be sure not to attach the front panel upside down.
• Do not press the front panel hard against the unit when
attaching it. Press it lightly against the unit.
• Do not press hard or put excessive pressure on the
display windows of the front panel.
• Do not expose the front panel to direct sunlight, heat
sources such as hot air ^cts, and do not leave it in a
humid place. Never leave it on the dashboard of a car
parked in direct sunlight where there may be a
considerable rise in temperature.
Caution alarm
If you turn the ignition key switch to the OFF
position without removing the front panel, the
caution alarm will beep for a few seconds
(only when the POWER SELECT switch is set
to the ® position).
Preparing the rotary
remote
When you mount the rotary remote, attach the
label in the illustration below.