Sony CDP-CE525 - Manual (Page 5)

Getting Started
lookups
Vhen connecting an audio cord, be sure to match the
olor-coded cord to the appropriate jacks on the
omponents: Red (right) to Red and White (left) to
Vhite. Be sure to make connections firmly to avoid
lum and noise.
CD player Amplifier
You can adjust the output level to the amplifier J
Press LINE OUT LEVEL + /- on the remote. You can
reduce the output level up to -20 dB.
When you reduce the output level, "
_ " appears in
the display.
Note
If vou press the LINE OUT LEVEL +/- buttons on the
remote while recording, the recording level will change
even when it is preset on the tape deck, etc.
'Q' If you have a Sony component with the CONTROL A1
jack
Connect the component via the CONTROL A1 jack. You
can simplify the operation of audio systems composed of
separate Sony components. For details, refer to the
supplementary "S-Link'''/CONTROL-A] Control
System" instructions.
'H' When using another Sony CD player together with
this player
You can make the supplied remote effective only for this
player.
• When using a player equipped with the COMMAND
MODE selector:
Leave the COMMAND MODE selector of this plaver
to CD 1 which is set at the factory and set that of
another player to CD 2 or CD 3. Then set the CD 1 / 2 / 3
switch on the remote supplied for each player
accordingly.
• When using a player not equipped with the
COMMAND MODE selector:
The command mode of the player without the
COMMAND .MODE selector is set to CD 1. Set the
COMMAND MODE selector of this player and the
CD 1 / 2 / 3 switch on the remote to CD 2 or CD 3.
If you have a digital component such as a digital
amplifier, D/A converter, DAT or MD
Connect the component via the DIGITAL OUT (OPTICAL)
connector using the optical cable (not supplied). Take off
the cap and plug in the optical cable.
Note that you cannot use fading in or out (page 22) and
Time Fade (page 23) functions W'hen making this
connection.
РОС-15
Optical cable (not supplied)
CD player Digital component
Connecting the AC power cord
Connect the AC power cord to a wall outlet.
Transporting the player
Before transporting the player, follow the procedure
below to return the internal mechanisms back to their
original position.
1
Remove all the discs from the disc tray,
2 Press = OPEN / CLOSE to close the disc tray.
"-NO DISC-" appears in the display.
3 Wait for 10 seconds, then press l/Ci) to turn off the
player.
Mote
When vou connect via the DIGITAL OUT (OPTICAL)
connector, noise mav occur when vou plav CD softrvare other
:han music, such as a CD-ROM.