Setting up the remote commander, About prosotting the commander, Note – Sony RM-V10A User Manual
Page 4
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Setting Up the Remote Commander
Befote you can start using the Remote Commander, you must
first set it up. This booklet describes everything you need to
know to setup the Commander, induding:
■ Installing the batteries (instructions are on page 5)
■ Presetting die Commander wiúi the codes for your TV, VCR,
and cable box (instructions begin on page 6)
About Prosotting the Commander
This Remote Commander is preset at die foctory to operate
Sony brand TVs (using code na 01) and Sony brand VHS
VCRs (using code na 01). If you're using diisCbnunander
with a Sony TV and a Sony VHS VCR, you won't need to
preset the Commander bd(»e you start using it
To set up this Remote Commander to use with other (non-
Sony) manufacturer's TVs, VCRs, and cable bwces, you'll need
to follow the instructions in diis booklet to preset the Remote
Commander with the correct code number for your TV, VCR.
and cable box.
Note
The
Commander
can be set tq> to operate only one component
ofeach category (TV, VCR, od>le box) at a time—unless their
code numbers tuqipen to be the same. For example, you cannot
set up the Commander to operate a Sony TV and a Panasonic
TV at the same dme (because they use different code numbers).