Sony XR-C7200 - Manual (Page 19)

Specifications
AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL HARMONIC DISTORTION
17 watts per channel minimum continuous average power into
4 ohms, 4 channels driven from 20 Hz to 20 kHz with no more than
1 % total harmonic distortion,
other specifications
Cassette player section General
Tape track 4-track 2-channel stereo Outputs Line outputs (2)
Wow and flutter 0.08 % (WRMS) Power antenna relay
Frequency response 30 - 20,000 Hz control lead
Signal-to-noise ratio Power amplifiercontrol
Cassette type Dolby B NR Dolby NR off
Tone controls
lead
Bass -»-8 dB at 100 Hz
TYPE II, m, IV 67 dB 61 dB Treble ±8 dB at 10 kHz
TYPE I 64 dB 58 dB Pow^r requirements 12 V DC car battery
(negative earth)
Tuner section Dimensions Approx. 184 X 50 X 176 mm
(wA/d)
FM
Mounting dimensions Approx. 182 X 53 X 163 mm
Tuning range 87.5-107.9 MHz (w/h/d)
Antenna terminal External antenna connector Mass Approx. 1.3 kg
Intermediate frequency 10.7 MHz Supplied accessories Parts for installation and
Usable sensitivity 8dBf connections (1 set)
Selectivity 75 dB at 400 kHz Front panel case (1)
Signal'to-noise ratio 65 dB (stereo). Optional accessories Rotary commander
68 dB (mono) RM-X2S(1)
Harmonic distortion at 1 kHz Wireless remote
0,5% (stereo). RM-X41 (1)
0.3% (mono) BUS cable (supplied with
Separation 35 dB at 1 kHz an RCA pin)
Frequency response 30- 15,000 Hz RC-61 (1 m), RC-62 (2 tn)
Capture ratio 2dB RCA pin cord
RC-63 (1 m)
AM
Optional equipment CD changer
Tuning range 530-1,710 kHz 10 discs:
Antenna terminal External antenna connector CDX-715
Intermediate frequency 10.71 MHz/450 kHz 6 discs:
Sensitivity 30 nV CDX-T65, CDX-T62
>
Q.
a.
r+
5‘
3
Power amplifier section
Outputs
Speaker impedance
Maximum power output
Speaker outputs
(sure seal connectors)
4-8 ohms
40 W
X 4 (at 4 ohms)
35W X 4 (at AM band, 4
ohms)
MD changer
MDX-62
Source selector
XA-C30
Design and specifications are subject to change without
notice.
19