Sony Cable Box - Manual (Page 24)

Connecting Other Equipment
Connecting video equipment to a stereo TV with an S video inp6t jack (KV-20TS32 only)
Rear of IV
Preparing for use
1
Turn on the TV.
2
Press the TV/VIDEO button on the TV or on the Remote
Commander so that “VIDEO” appears on the screen.
When you cannot obtain a clear picture and/or sound
Make sure that the TV/VTR on the VCR is set to TV.
Reselect the channel you want to view with the controls on
the TV or the Remote Commander.
About S video input
Video input and output signals can be separated into Y
(luminance or brightness) and C (chroma or color) signals.
Usually these two signals are combined in a VCR and sent
as one signal to a TV. Separation of the Y and C signals
prevents them from interfering with one another, thereby
improving picture (especially color) quality.
This TV is equipped with an S video input jack through
which these separated signals can be input directly. This
way you can connect your S video-equipped VCR
separately from a non-S video VCR.
To return to TV mode
Press the TVA/IDEO button on the TV or Remote Commander so
that a channel number appears on the screen.
For operating instructions, refer to the instruction manual
furnished with the VCR.
If the picture or sound is affected, move the VCR away
from the TV.
If S VIDEO is set to OFF, you cannot watch VCR
playback pictures from the S VIDEO Input.
To set S VIDEO to ON, see “Watching a Video with Your
S Video-Equipped VCR,” p. 27.
24 Chapter 1 : Setting Up