Sony CPD-110GS - Manual (Page 7)

If no picture appears on your screen
• Check that the monitor is correctly connected to the computer.
• If NO INPUT SIGNAL appears on the screen, confirm that
your computer's graphic board is completely seated in the
correct bus slot.
• If you are replacing an old monitor with this model and OUT
OF SCAN RANGE appears on the screen, reconnect the old
monitor. Then adjust the computer's graphTc board so that the
horizontal frequency is between 30 - 70 kHz. and the venicai
frequency is between 48 - 120 Hz.
For more information about the on-screen messages, see "Trouble
symptoms and remedies" on page 14.
For customers using Windows 95/98
To maximize the potemiai of your monitor, install the new model
information file from the supplied Windows Monitor information Disk
onto your PC.
This monitor complies with the “VESA DDC" Plug & Play standard, if
your PC/graphics board complies with DDC. select "Plug & Play Monitor
(VESA DDC)" or this monitor's model name as the monitor type in the
"Control Panel” of Windows 95/98. If your PC/graphics board has
difficulty communicating with this monitor, load the Windows Monitor
Information Disk and select this monitor’s model name as the monitor
type.
For customers using Windows NT4.0
Monitor setup in Windows NT4.0 is different from Windows 95/98 and
does not involve the selection of monitor type. Refer to the Windows
NT4.0 instniction manual for further details on adjusting the resolution,
refresh tale, and number of colors.
Adjusting the monitor’s fbsolutlon and color number
Adjust the monitor’s resolution and color number by referring to your
computer’s instruction manuai. The color number may vary according to
your computer or video board. The color palette setting and the actual
number of colors are as follows:
• High Color (16 bit)—► 65.535 colors
• True Color (24 bit) —► about 16.77 million colors
In true color mode (24 bit), speed may be slower.
Selecting the on-screen menu
language (LANGUAGE/
INFORMATION)
English. French. German. Spanish, and Italian versions of the on­
screen menus are available. The default setting is English.
1 Press the MENU button.
See page 9 for more information on using the MENU button.
rj CONTRAST / BR IGHTNESS
SH-$i2S/CEtO№R
tBV-SIZE/CENTER
nPIN/PIN BALANCE
QKEY/KEY BALANCE
O
rotation
SZOOM
G3 COLOR
--♦RESET
Q LANGUAGE/INFORMATI ON
nDEGAUSS/CANCEL MOIRE
Press the +!- buttons to highlight Q LANGUAGE/
iNFORMATION and press the ENTER button.
See page 9 for more information on using the -W- and ENTER
buttons.
WSi
•ENGLISH -FRANÇAIS
•DEUTSCH -ITALIANO
•ESPAÑOL
sELECT-tga ExiT-»m
3 Press the ENTER button to seiect Q (LANGUAGE)
and press -U- buttons to seiect a language.
• ENGLISH
• FRANÇAIS: French
• DEUTSCH; German
• ESPAÑOL; Spanish
• ITALIANO: Italian
To close the menu
Press the MENU button once to return to the main menu, and twice to
return to normal viewing. If no bunons are pressed, the menu closes
automaticaliv after about 30 seconds.
To reset to English
See “Resetting the adjustments (RESET)" on page 12.