Note on the remaining battery indicator, Notes on the rechargeable battery pack, Caution – Sony CCD-TR54 User Manual
Page 35: The battery heats up, Battery pack care, How to use the switch on the battery pack, The life of the battery pack, Tips for using the battery pack
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Tips for Using the Battery Pack
When the remaining battery indicator reaches the lowest point, the indicator appears and starts
flashing in the viewfinder,
[b]
When the <Xi indicator in the viewfinder changes from slow flashing to rapid flashing while you are
recording, turn the POWER switch to OFF on the camcorder and replace the battery pack. Lea\’e the tape
in the camcorder to obtain smooth transition between scenes after the battery is replaced.
Note on the remaining battery indicator
The remaining battery indicator of the camcorder may indicate a different remaining capacity from that
of the battery pack with the remaining battery indicator (not supplied). The indicator of the battery pack
is more accurate.
o
c
Notes on the Rechargeable Battery Pack
Caution
Never leave the battery pack in temperatures nbo\ e 140 ’F (60 ”C), such as in a car parked in the sun or
under direct sunlight.
The Battery Heats Up
During charging or recording, the battery pack heats up. This is caused by energy that has been
generated and a chemical change that has occurred inside the battery pack. This is not cause for concern.
Battery Pack Care
• Remove the battery pack from the camcorder after using the battery pack, and keep it in a cool place.
When the battery pack is attached to the camcorder, a small amount of current flows to the camcorder
even if the POWER swatch is set to OFF, vc'hich shortens battery life.
• The battery pack is ahvays discharging evtn whOn it is not in use after charging. Therefore, you should
charge the battery right before using the camcorder.
How to Use the Switch on the Battery Pack
When the switch is supplied with the battrv pack
([c] on p. 36) you can use it to find whether the battery
pack is charged or not. Set the switch to the "no mark" position when charging is completed. Set the
switch to the "red mark" position when the batter\ is used up (or in w'hichever direction vou want to
remind yourself).
The Life of the Battery Pack
If the <Xi indicator flashes rapidly just after turning on the camcordrer with a fully charged batter\- pack,
the battery pack should be replaced with a new fully charged one.
35