Sony KV-32S15 - Manual (Page 25)

Operating video equipment
Video operating
buttons
Use the video operating buttons on the remote
commander to operate the video equipment.
Operating a VCR Buttons on the remote
commander
To turn on or off Press POWER
To change channels Press CH +/-
To record Press # and REC
simultaneously
To play
Press ►
To stop
Press ■
To fast forward
Press ►►
To rewind the tape
Press
To pause
Press II
To search the picture
forward and backward
Press ►► or ◄◄ during
playback
Operating the laser-disc
player Buttons on the remote
commander
To play Press ►
To stop Press ■
To pause Press II
To resume normal playback,
press again.
To search the picture
forward and backward Keep pressing ►► or ◄◄
during playback
To resume normal playback,
release the button.
To search the chapter Press CH +/-
Note
• If the video equipment does not have a certain function, the
corresponding button on this remote commander will not
operate.
Operating a cable
box
For cable box control (Cable Mouse) users
(KV-27V1SI32V1SI32V16 only)
Set the CABLE BOX/TV selector to TV and
disregard the instruction below.
Follow these instructions to set the manufacturer's code
which will enable you to operate a connected cable box
with the pre-programmed remote commander. For
example, you can set the remote commander to operate
a connected Zenith cable box.
MODE
Low position
POWER (CABLE)
CODE SET
CH +/-
CABLE BOX/TV
selector
1
Set the CABLE BOX/TV selector to CABLE
BOX.
CABLE BOX. .TV
2
While pressing CODE SET, press 6 and 8
(Zenith's code number —see chart on the
next page) and ENTER.
( code set ! (
+
(continued)
Operations 25