Sony CAV-1 - Manual (Page 11)

m
Preparation
Hints on handling the Air-EGG
• A slight move of the wrist is all you need to
direct the pointer (see illustration on the
previous page).
• Hold the Air-EGG with its "click" button facing
up, as shown below. If the dick button is
oriented diagonally, the on-screen pointer will
alsojae oriented diagonally.
' The Air-EGG will not operate if you move it
parallel as shown below.
X
• If the pointer has not reached the desired point
by the time you finish moving the Air-EGG,
release the click button, move the Air-EGG back,
lightly hold down the click button, then continue
moving the pointer again.
Notes
• If the pointer begins drifting on the screen
whiie the Air-EGG is stationary, place the Air-
EGG on a flat surface for a few seconds. The
pointer should behave normally when you
operate the Air-EGG again.
• The pointer may drifft when it is used for more
than 5 continuous minutes. It also mav drifft
due to changes in the surrounding temperature.
• If the pointer response is too sensitive, do the
procedure in "To adjust the Air-EGG" on this
page.
• The pointer freezes on the screen when you
release the click button.
Caution
Since the Air-EGG contains delicate circuitry and
parts, do not subject it to sudden changes in
temperatures or to shock.
To adjust the Air-EGG*
• Adjusting the sensitivity of the Air-EGG.
Press CEI or CZl while holding down the control
key. The sensitivity of the Air-EGG can also be
adjusted by adjusting the mouse sensitivity on
the PC.
• Adjusting the steadiness of the Air-EGG while
being held.
Press B or S while holding down the control
key. Note that poor response may result when
the steadiness of the Air-EGG is set too high.
• This function is available only when the RS232C
cable is connected.
11