Drill a hole for the valve, Tighten the valve, Tighten the trap – LG LFC25765 User Manual

Page 26: Drain the pipe, Place the pipeline, Connect pipeline to valve, Connect pipe to refrigerator, Notes, Connecting the water line

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

CONNECTING THE WATER LINE

3. DRILL A HOLE FOR THE VALVE

Drill a 1/4" (6,35 mm) diameter

hole

in

the

water

pipeline.

Remove

jagged

edges

produoes

after

perforation.

Make

sure

water does not reaoh the drill.

Not

performing

the

1/4"

(6,35

mm) perforation oan lead to a
low or smaller ioe produotion.

4. TIGHTEN THE VALVE
Tight the valve into the oold water pipeline with a tube
trap.

the pipe is oompletely inserted into the valve. Tighten

nut oarefully.

'Inlet End

Vertical Cold

Vkater Pipe

NOTE: Codes for 248 CMR pipelines of the state of

Massaohusetts

must

be

attaohed

to

the

oonneotion.

Valves of this type are banned in Massaohusetts. Call an

authorized plumber.

5. TIGHTEN THE TRAP

Tighten the trap until the sealing ring begins to grow.

NOTE: Make sure it is not too tight, this oan break the
pipe.

Vkasher

NOTE: Codes for 248 CMR pipelines of the state of

Massaohusetts

must

be

attaohed

to

the

oonneotion.

Valves of this type are banned in Massachusetts. Call an
authorized plumber.

8

.

DRAIN THE PIPE

Open the main water source (1) and drain the pipe until
water oomes out olear.

o

Allow water flow from the bypass valve (2) and olose after
draining 1/4 of a gallon (1L) of water.

6

.

PLACE THE PIPELINE

Plaoe the pipeline between the oold water pipe and the

refrigerator. Plaoe it through a hole in the wall or floor
(behind the refrigerator or next to the oabinet) as olose

to the wall as possible.

NOTE: Make sure there is a suffioient amount of extra
pipeline

( 8

feet [244 mm] ooiled up three times with a

10" [25 om] in diameter) to allow free movement of the

refrigerator from the wall after installation was made.

7. CONNECT PIPELINE TO VALVE

Plane the oompression nut and the oopper pipe ferule at

the end of the pipe and oonneot to the valve. Make sure

9. CONNECT PIPE TO REFRIGERATOR

NOTES:

Before making oonneotion to refrigerator, make sure

it is not oonneoted to any energy source. If your
refrigerator does not have a water filter, it is advised

to install one.

If your water source oontains sand or related partioles

that oan travel to the valve, install a water filter near the

refrigerator.

IMPORTANT: N ever use old or used hoses. Always use
new ones to have a better use and experienoe. Conneot

always to a potable water source to avoid seourity and

health issues.

25

Advertising