Awarning, Cutting height adjustment levers, Mulching baffle – Craftsman 247.38528 User Manual
Page 13: Gas cap, Oil fill cap/ dipstick, Spark plug, Trail shield, Meets ansi safety standards, Operation
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
OPERATION
The blade control is attached to the upper handle of the mower.
Depress and squeeze it against the upper handle to operate the unit.
Release it to stop engine and blade.
AWARNING
This blade control is a safety device. Never attempt to bypass its
operations.
CUTTING HEIGHT ADJUSTMENT LEVERS
One adjustment lever is located on each wheel and is used to adjust
the cutting height. All four levers have to be at the same position to
ensure a uniform cut.
MULCHING BAFFLE
The mulching baffle is used to recirculate grass clippings back to the
lawn. Attach it as instructed in the Assembly section of this manual.
The recoil starter is attached to the right upper handle. Stand behind
the unit and pull the recoil starter rope to start the unit.
GAS CAP
Remove the gas cap to add fuel to the fuel tank. Use clean, fresh,
regular unleaded gasoline with a minimum of 87 octane.
OIL FILL CAP/ DIPSTICK
Refer to the Maintenance section for instructions on checking the oil.
SPARK PLUG
Refer to the Maintenance section for instructions on spark plug
replacement.
TRAIL SHIELD
The trail shield is attached to the rear of the mower and is there to
protect the operator from flying debris. Do not use the mower unless
the shield is fully functional and in place.
Meets ANSI Safety Standards
Craftsman Lawn Mowers conform to the safety standard of the American National Standards Institute (ANSI).
13