Troubleshooting, Need more help, Problem cause remedy – Craftsman 247.38528 User Manual

Page 21

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

TROUBLESHOOTING

I

Problem

Cause

Remedy

Engine fails to start

1.

Blade control disengaged.

2.

Spark plug boot disconnected.

3.

Fuel tank empty or stale fuel.

4.

Faulty spark plug.

5.

Engine flooded.

6.

Blocked fuel line.

1.

Engage blade control.

2.

Connect wire to spark boot.

3.

Fill tank with clean, fresh gasoline.

4.

Clean, adjust gap, or replace.

5.

Walt a few minutes to restart.

6.

Contact your Sears Parts & Repair Center to have

fuel line cleaned.

Engine runs erratically

1.

Spark plug boot loose.

2.

Stale fuel.

3.

Vent in gas cap plugged.

4.

Water or dirt in fuel system.

5.

Dirty air cleaner.

6.

Blocked fuel line.

1.

Connect and tighten spark plug boot.

2.

Fill tank with clean, fresh gasoline.

3.

Clear vent.

4.

Run engine until it stops from lack of fuel. Refill with

fresh fuel.

5.

Refer to Air Cleaner in Engine Maintenance section.

6.

Contact your Sears Parts & Repair Center to have

fuel line cleaned.

Engine overheats

1.

Engine oil level low.

2.

Airflow restricted.

1.

Fill crankcase with proper oil.

2.

Clean area around and on top of engine.

Occasional skips (hesitates)

1. Spark plug gap too close.

1. Adjust gap to .030”.

Idles poorly

1.

Spark plug fouled, faulty, or gap too wide.

2.

Dirty air cleaner.

1.

Reset gap to .030” or replace spark plug.

2.

Refer to Air Cleaner in Engine Maintenance section.

Excessive vibration

1.

Cutting blade loose or unbalanced.

2.

Bent cutting blade.

1.

Tighten blade and adapter. Balance blade.

2.

Replace blade.

Mower will not mulch grass

1.

Wet grass.

2.

Excessively high grass.

3.

Dull blade.

1.

Do not mow when grass is wet; wait until

later to cut.

2.

Mow once at a high cutting height, then mow again

at desired height or make a narrower cutting path.

3.

Sharpen or replace blade.

Uneven cut

1.

Wheels not positioned correctly.

2.

Dull blade.

1.

Place all four wheels in same height position.

2.

Sharpen or replace blade.

NEED MORE HELP?

You'll

find

the answer and more

on

managemyhome.com - for free!

Find this and all your other product manuals online.

Get answers from our team of home experts.

” Get a personalized maintenance plan for your home.

Find information and tools to help with home projects.

Î ¡11,I I

brought to you by Sears

21

Advertising