Assembly / pre-operation – Craftsman 917.881064 User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ASSEMBLY / PRE-OPERATION
INSTALL TRACTION DRIVE CONTROL ROD
(See Figs. 3 and 4)
The traction drive controi rod has the iong ioop on the end
of the spring as shown,
1, Siide rubber sieeve up rod and hook end of spring into
pivot bracket with ioop opening down as shown,
2, With top end of rod positioned under ieft side of controi
panei, push rod down and insert top end of rod into hoie
in drive controi bracket. Secure with retainer spring.
INSTALL AUGER CONTROL ROD (See Figs. 5 and 6)
The auger controi rod has the short ioop on the end of the
spring as shown,
1, Siide rubber sieeve up rod and hook end of spring into
controi arm with ioop opening up as shown,
2,
With top end of rod positioned under right side of
controi panei, push down on rod and insert end of rod
into hoie in auger controi bracket. Secure with retainer
spring.