Accessories and attachments, Tools needed for assembly – Craftsman 137.212290 User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ACCESSORIES AND ATTACHMENTS
TOOLS NEEDED FOR ASSEMBLY
RECOMMENDED ACCESSORIES
A WARNING
• Use only accessories recommended for this
miter saw. Follow instructions that accompany
accessories. Use of improper accessories may
cause hazards.
• The use of any cutting too! except 10 inch saw
blades which meet the requirements under
recommended accessories is prohibited. Do
not use accessories such as shaper cutters or
dado sets. Ferrous metal cutting and the use of
abrasive wheels is prohibited.
• Do not attempt to modify this tool or create
accessories not recommended for use with
this tool. Any such alteration or modification is
misuse and could result In a hazardous condition
leading to possible serious Injury.
ACCESSORIES
Visit your Sears Hardware Department or see the
Sears Power and Hand Tool Catalog to purchase
recommended accessories for this power tool.
A WARNING
To avoid the risk of persona! injury, do not
modify this power tool or use accessories not
recommended by Sears.
A WARNING
Read warnings and conditions on your CARBIDE
TIPPED SAW BLADE. Do not operate the saw
without the proper saw blade guard in place.
Carbide is a very hard but brittle material. Care
should be taken while mounting, using, and storing
carbide tipped blades to prevent accidental damage.
Slight shocks, such as striking the tip while
handling, can seriously damage the blade. Foreign
objects in the workpiece, such as wire or nails, can
also cause tips to crack or break off. Before using,
always visually examine the blade and tips for bent
blade, cracks, breakage, missing or loose tips, or
other damage. Do not use if damage is suspected.
Failure to heed safety instructions and warnings can
result in serious bodily injury.
o:
3
Blade Wrench (supplied)
Philips Screwdriver
Adjustable Wrench
Hex Key 2.5 mm
Combination Square
COMBINATION SQUARE MUST BE TRUE
straight edge or
a 3/4 in. board,
Draw light line on board
along this edge.
perfectly straight.
Should not gap or overlap when
square is flipped over (see
dotted figure).