Maintenance – Craftsman 315.115042 User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
MAINTENANCE
WARNING:
When servicing use only identical
Craftsman replacement parts. Use of any other
parts may create a hazard or cause product
damage.
GENERAL
Only the parts shown on parts list, page 13, are intended
to be repaired or replaced by the customer. All other parts
represent an important part of the double insulation system
and should be serviced only at a qualified service center.
Avoid using solvents when cleaning plastic parts. Мой
plastics are susceptible to various types of commercial
solvents and may be damaged by their use. Use clean
cloths to remove dirt, carbon dust, etc.
Д WARNING:
Do not at any time let brake fluids,
gasoline, petroleum-based products, penetrating
oils, etc. come in contact with plastic parts. They
contain chemicals that can damage, weaken, or
destroy plastic.
When electric tools are used on fiberglass boats, sports
cars, wallboard, spackllng compounds, or plaster, it has
been found that they are subject to accelerated wear and
possible premature failure, as the fiberglass chips and
grindings are highly abrasive to bearings, brushes,
commutators, etc. Consequently it is not recommended
that this tool be used for extended work on any fiberglass
material, wallboard, spackllng compounds, or plaster.
During any use on these materials. It is extremely
important that the tool is cleaned frequently by btowing
with an air jet.
^ WARNING:
Always wear safety goggles, or safety
glasses with side shields during power tool
operation or when blowing dust. If operation is
dusty, also wear a dust mask.
EXTENSION CORDS
The use of any extension cord will cause some loss of
power. To keep the loss to a minimum and to prevent tool
overheating, follow the recommended cord sizes on the
chart below. When tool is used outdoors, use only
extension cords suitable for outdoor use and so marked.
Extension cords are available at Sears Retail Stores.
Length of Extension Cord Wire Size (A.W.G.)
UptoSOfeet
16
SCMOOfeet
14
A CAUTION
: Keep extension cords away from the
sanding area and position the cord so that it will not
get caught on lumber, tools, etc., during sanding
operation.
A WARNING:
Check extension cords before each
use. If damaged, replace immediately. Never use
tool with a damaged cord since touching the
damaged area could cause electrical shock resulting
in serious injury.
LUBRICATION
All of the bearings in this tool are lubricated with a suffi
cient amount of high grade lubricant for the life of the unit
under normal operating conditions. Therefore, no further
lubrication is required.