Craftsman 315.111450 - Manual (Page 5)

OPERATION
KNOW YOUR DRILL
See Figure 1.
Before attempting to use your drill, familiarize
yourself with all operating features and safety re­
quirements.
If any parts are missing do not operate your drill until
Ihemlssingparts are replaced.
iiWARNINGt DO; NOTi ALLOWSFAMILIARITY
WITH YOUR DRILL TO MAKE YOU CARELESS.
REMEMBER THAT A CARELESS FRACTfON OF A
SECOND IS SUFFiCiENT TO INFLICT SEVERE
'INJURY.
AWARNING: ALWAYS WEAR SAFETY GOG-
;GLES OR SAFETY GLASSES WITH SIDE SHIELDS
WHEN OPERATING YOUR DRILL. FAILURE TO
DO SO COULD RESULT IN OBJECTS BEING
THROWN INTO YOUR EYES, RESULTING IN
POSSIBLE SERIOUS INJURY.
CHARGING YOUR DRILL
Your drill has been shipped in a low charge condition
to prevent possible problems. Therelore, you should
charge It at least 5 hours prior to use
NOTE-.Your drill will not reach full charge the first
time It Is charged. Allow several cycles (drilling
followed by recharging) for your drill to become fully
charged.
TO CHARGE
1. Connect charger to your drill by inserting
charger plug Into input (ack. NOTE: As shown in
Figure 1, input lack is located at the rear of tool.
2 Charger can be used with normat house voflage
of tIO-IZO volts, 60 Hz. AC only.
3. Connect charger to power supply
NOTE: The LED Indicator, which is located above the
switch, will light up when charger is properly con­
nected to power supply This light indicates your
drill Is charging and will remain on until charger Is
disconnected from power supply.
NOTE: Do not operate your drill while it is connected
to the charger. The driving ability of your drill wit! not
Increase.
NOTE: After normal usage, your drill usually requires
3 hours of charging lime to be fully charged
YOUR DRILL CONTAINS SPECIAL
HIGH TEMPERATURE BATTERIES TO HELP PRE­
VENT
BATTERY DAMAGE WHEN LEFT ON
CHARGE FOR EXTENDED PERIODS OF TIME.
HOWEVER, ONCE THE BATTERIES OF YOUR DRILL
BECOME
FULLY CHARGED, WE RECOMMEND
THAT YOU UNPLUG YOUR CHARGER FROM
POWER SUPPLY THEN DISCONNECT THE
CHARGER FROM YOUR DRILL
DRILL
INPUT JACK
CHARGER PLUG
BATTERY CHARGER
Fig 1
Page 5