Operation (cont.) – Craftsman 315.111450 User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
BATTERIES
Your dtiil is equipped with 5 nickei-cadmium
rechargeable batteries Length of service from each
charging will depend on the type of work you are do
ing
The nickei-cadmium batteries in this tool have been
designed to Iasi for the life of the unit under normal
operating conditions. Therefore, do not disassemble
your drill and attempt to replace them, Handling of
these batteries, especially when wearing rings and
ieweity, could result in a serious burn
WRIST STRAP
f
A wrist strap Is provided to reduce the chances of
dropping your drill. Place one hand through wrist
strap when carrying your drill See Figure 4,
SWITCH
The switch on your drill is designed for single speed
drilling For normal drilling operation, depress the
switch trigger all the way.
OPERATION (Cont.)
REVERSIBLE
Your drill has the feature of being reversible The
direction of rotation is controlled by a selector
iocated above the switch trigger. See Figure 2. With
your drill held in normal operating position, the
direction of rotation selector should be positioned to
the left of the switch for drilling The drill direction is
reversed when the selector is to the right of the
switch When the selector is in center position, the
switch trigger is locked.
ACAUTION:
___ TO PREVENT GEAR DAMAGE.
ALWAYS ALLOW THE CHUCK ON YOUR DRILL TO
COME TO A COMPLETE STOP BEFORE CHANGING
THE DIRECTION OF ROTATION
To stop yout drii). release switch trigger and ailow
your drill to come to a complete stop
ikWARNSNGr BATTERY TOOLS ARE ALWAYS IN
;;OP£RATING.edNDitlON.
therefor
E. SWITCH
SHOULD ALWAYS BE LOCKED WHEN NOT IN
USE QRiCARRYfNG AT YOUR SIDE.
NOTE: To lock switch trigger, place the direction of
rolaliort selector in center position. See Figure 2
CHUCK KEY
A chuck key has been packed with your drill for use
when installing or removing bits, if is also used when
removing the chuck. See Figure 3
CHUCK KEY STORAGE
When not in use. the chuck key can be placed in the
storage area located on the back of your drill See
Figure 3
Page 6