Craftsman 358.797922 - Manual (Page 11)

s. Моте away from tbefbel tank and melttheeaâs of
thetnpe,
9. AOoweadi malted end to drift onc^ then whSei&e
rope is stai hot, pull each melted end through a
clean rag to ohta£a a smooth, pointed end.
10. Insert one end of the rope throng the handle and
secure with a knot. Leave ЗД6” pàgtaüb^imâ the
knot. ISgure 18 Clhset).
11. hisertthe otlœr end of the rope throu^ denudai
grommet, then xmder the K(^e Guide, iïgure 18­
12. Guide rope inside the pulley, then throat Pulley
Hole. Kgore 17.
13, Wrap rope counierdocfcwise around the pull^
ratchet and tuck the Jbose end bac|c_under. .Ihe
rope,leaivincaboutalinchtaiÌncsrttó8iièRetain-
eriîïb, KgurelD.
Id^InstaU and tighten the Betainer Screw/Washer.
Figure 17. ,
NCraii^ fio not overti^ten the Eetainer Screw,
Over tightening flie screw can саше the screw
postto strip oat-
the screw until the bot­
tom of the washer eUher (1) is snug against the
rope or (2) contacts the top of the screw post
15.Pull the rope ti^itly around the pull^ratchet.
l8.SKght!ypull the rope to relieve the poeessure on thè
bex wrmch. Remove the hex wrench and allbw
(he ropeito rewind slowly.
17.1Bea^embb the Pulley Housing to the engine,
lîghten screws secarefy.
yrOTEt Be sure the rubber O—Bing is installed
onto the i^ey housing. See
18~Align the hole in the impeDer rrith the impeller
slShmakfiig sure thé flat sides are aligned. Kg-
UreSO.
• '
NCynSi When reassembling the bni^iler Hous­
ing to (he En^e Shroud, be sure not to over-
tii^ten screws. Overtightening the screws can
strip out the Ьпрейег Housing.
19. Assemble parts by reversing steps 1. tbroa^ 4-
РцДеу
Notdi
Po]teyB^aL»4Ì\
Tato ¿id 8стту''>А
б
Housing Noteh
РоИпУ Ratchet
Yl
Retainer Rib
Kit
Воре Betainer
Scsrew/Wariim’
Kguyeie
Pulley Ratchet.
Воре
Retainer
Screw/^asher
ВореВД
лесашт-
FigurelS
U-