Craftsman 917.273062 - Manual (Page 19)

4. Move motion control lever to full
forward position and hold for five (5)
seconds. Move lever to fuli reverse
position and hold for five (5) seconds.
Repeat this procedure three {3) times.
NOTE: During this procedure there will be
no movement of drive wheels. The air is
being removed from hydraulic drive
system.
5. Move motion control lever to neutral
(N) position. Shut- off engine and set
parking brake.
6. Engage transmission by placing
freewheel control in driving position
(See “TO TRANSPORT” in this section
of manual).
7. Sitting in the tractor seat, start engine.
After the engine is running, move
throttle control to half (1/2) speed. W ith
motion control lever in neutral (N)
position, slowly disengage clutch/
brake pedal.
8. Slowly move motion control lever
forward, after the tractor moves
approximately five (5) feet, slowly
move motion control lever to reverse
position. After the tractor moves
approximately five (5) feet return the
motion control lever to the neutral (N)
position. Repeat this procedure with
the motion control lever three (3)
times.
Your tractor is now purged and now ready
for normal operation.
MOWING TIPS
• Tire chains cannot be used when the
mower housing is attached to tractor.
• Mower should be properly leveled for
best mowing performance. See ‘TO
LEVEL MOW ER HOUSING” in the
Service and Adjustments section of this
manual.
« The left hand side of mower should be
used for trimming.
• Drive so that clippings are discharged
onto the area that has been cut. Have
the cut area to the right of the tractor.
This will result in a more even distribu­
tion of clippings and more uniform
cutting.
• W hen mowing large areas, start by
turning to the right so that clippings will
discharge away from shrubs, fences,
driveways, etc. After one or two
rounds, mow in the opposite direction
making left hand turns until finished.
• if grass is extremely tall, it should be
mowed twice to reduce load and
possible fire hazard from dried dip­
pings. Make first cut relatively high; the
second to the desired height.
• Do not mow grass when it is wet. W et
grass will plug mower and leave
undesirable dumps. Allow grass to dry
before mowing.
• Always operate engine at full throttle
when mowing to assure better mowing
performance and proper discharge of
material. Regulate ground speed by
selecting a low enough gear to give the
mower cutting performance as well as
the quality of cut desired.
« W hen operating attachments, select a
ground speed that will suit the terrain
and give best performance of the
attachment being used.
( '
i,
: )
(_________ _
1
19