To replace headlight bulb, Interlocks and relays, To adjust attachment lift spring – Craftsman 917.273062 User Manual
Page 30: To remove hood and grill assembly, To adjust throttle control cable
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
TO REPLACE HEADLIGHT BULB
1. Raise hood.
2. Pull bulb holder out of the hole in the
backside of the grill.
3. Replace bulb in holder and push bulb
holder securely back into the hole in
the backside of the grill.
4. Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your
tractor to run poorly, stop running, or
prevent it from starting.
• Check wiring. See electrical wiring
diagram in the Repair Parts section.
TO REPLACE FUSE
Replace with 30 amp automotive-type
plug-in fuse. The fuse holder is located
behind the dash.
TO ADJUST ATTACHMENT LIFT
SPRING
1. W hile holding spring bushing with
wrench, loosen jam nut.
• Turn adjustment bolt clockwise to
extend spring and reduce lift effort for
heavier attachments.
• Turn adjustment bolt counterclockwise
for lighter attachments.
2. Retighten jam nut against spring
bushing.
IMPORTANT:
Do not adjust for maximum
spring tension when using light attach
ments such as a mower. Adjust lift lever
spring to aid in lifting attachment. Do not
overpower spring. W hen removing
attachment, always adjust spring tension
to its lowest position.
/f~] Adjustment Bolt
Bushing
Attachment Lift
Spring
Jam Nut
TO REMOVE HOOD AND GRILL AS
SEMBLY
1. Raise hood.
2. Unsnap headlight wire connector.
3. Stand in front of tractor. Grasp hood at
sides, tilt toward engine and lift off of
tractor.
4. To replace, reverse above procedure.
Maintenance, repair, or replacement of
the emission control devices and sys
tems, which are being done at the
customers expense, may be performed
by any non-road engine repair establish
ment or individual. W arranty repairs must
be performed by an authorized engine
manufacturer's service outlet.
TO ADJUST THROTTLE CONTROL
CABLE
The throttle control has been preset at the
factory and adjustment should not be
necessary. Check adjustment as de
scribed below before loosening cable. If
adjustment is necessary, proceed as
follows;
1. W ith engine not running, move throttle
control lever to fast position.
2. Check that speed control lever is
against stop screw. If it is not, loosen
casing clamp screw and pull throttle
cable until lever is against screw.
Tighten clamp screw securely.
Idle Fuel Adjusting Idle speed Adjusting
30