Craftsman 247.88110 - Manual (Page 7)

d. Secure the two (2) upper handles together with
one (1) Hex Hd. Bolt % - 2 0 x l % " and one (1)
Hex Center Lock Nut '/4-20 Thd.
NOTE: Do not tighten. See figure 8.
e. Place the two (2) upper handles assembled in
position with the lower handle. See figure 9.
FIGURE 9. HANDLE AND BRACE ASSEMBLY
f. Place a bolt, regardless of length, in the top hole
of the lower handle to help hold handle in po­
sition when working.
g. The right and left hand braces have five (5) hole
locations for mounting the braces to the lower
handle. The reason for having five (5) hole lo­
cations is so that you may adjust the handle
height to suit you.
h. Upon selecting the desired height of handle,
secure with one (1) Hex Hd Bolt ’^-20xl'/i"
and one Hex Center Lock Not '^-20 Thd.
NOTE: Use the bottom hole of lower handle
only. See figure 9. Do not tighten.
FIGURE 10. THROTTLE CLAMP ASSEMBLY
Step 3.
a. Place the speednut on the throttle clamp. See fig­
ure 10.
Throttle Clamp
with Speed Nut
Upper Handles %
«Hex Hd. Bolt
'4-20x1'/ 2 "
stable Wrench
Hex Center Lock Nut
'/ 4-20 Thd.
FIGURE 11. THROTTLii CLAMP ASSEMBLY
b. Place the throttle clamp with speed nut in po­
sition on upper handle.
NOTE: Be sure the speed nut is towards the top
of handle. See figure 11.
c. Secure the throttle clamp with one (1) Hex Hd.
Bolt 14-20x1 VS" Long end one (1) Hex Center
Lock Nut 14-20 Thd.