Step 5: (see figure 6) – Craftsman 486.24611 User Manual
Page 4
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
STEP 2
:
(SEE FIGURE 3)
•
Remove tractor hood. (Refer to tractor manual.)
•
Remove the browning shield as shown.
STEP 3: (SEE FIGURE 4)
• Place plug on a work bench or solid table and push
end of bumper down onto plug. Repeat for all plugs.
STEP 4: (SEE FIGURE 5)
• Insert a carriage bolt into the second mounting hole
from the front of the tractor frame and fully tighten a
whiziock nut onto the bolt. Repeat on other side of
tractor.
STEP 5: (SEE FIGURE 6)
•
Spread ends of bumper enough to fit slots onto bolts
in rear mounting holes in tractor frame.
•
The bumper has three mounting holes. The rear
hole provides the most clearance while the forward
holes provide a neater appearance. Use a hole
that provides enough clearance for hood to stay in
raised position when opened. Insert a carriage bolt
and washer through tractor frame and into desired
mounting hole on each side of bumper and secure
with a whiziock nut.
IMPORTANT: Before fully tightening nuts, be sure
tractor hood will stay in raised position when opened.
Call 1 -866-576-8388 for missing parts or assembly help
DO NOT RETURN TO STORE