Operation – Craftsman 315.11910 User Manual
Page 9
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
OPERATION
M. WARNING^ Do
not allow familiarity with tools to
make you careless. Remember that a careless
fraction of a second Is sufficient to Inflict serious
Injury,
Ak WARNING:
Always wear safety goggles or safety
glasses with side shields when operating tools.
Failure to do so could result In objects being thrown
Into your eyes, resulting In possible serious Injury,
A WARNING:
Do not use any attachments or
accessories not recommended by the manufacturer
of this tool. The use of attachments or accessories
not recommended can result In serious personal
Injury,
APPLICATIONS
You may use this product for the purposes listed below:
■ Drilling In all types of wood products (lumber, plywood,
paneling, composition board, and hard board)
■ Drilling In ceramics, plastics, fiberglass, and laminates
■ Drilling In metals
This product will accept Diehard® 19.2 V llthlum-lon bat
tery packs and Craftsman 19.2 V nickel-cadmium battery
packs.
For complete charging Instructions, refer to the Operator’s
Manual for the battery packs and chargers listed In the
General Safety Rules.
BATTERY PROTECTION FEATURES
Diehard® 19.2 V llthlum-lon battery packs are designed
with features that protect the llthlum-lon cells and
maximize battery life.
If the tool stops during use, release the trigger to reset
and resume operation. If the tool still does not work, the
battery needs to be recharged.
TO INSTALL BATTERY PACK
See Figure 2.
■ Lock the switch trigger by placing the direction of
rotation selector In the center position,
■ Place battery pack In the tool. Align raised rib on
battery pack with groove Inside tool.
■ Make sure the latches on each side of the battery pack
snap Into place and battery pack Is secured In tool
before beginning operation,
CAUTION:
When placing battery pack In the tool,
be sure raised rib on battery pack aligns with groove
Inside tool and latches snap Into place properly.
Improper assembly of battery pack can cause
damage to Internal components.
TO REMOVE BATTERY PACK
See Figure 2.
■ Lock the switch trigger by placing the direction of
rotation selector In the center position,
■ Locate latches on end of battery pack and depress to
release battery pack from the tool.
■ Remove battery pack.
WARNING:
Battery products are always In operat
ing condition. Therefore, the switch should always
be locked when not In use or carrying at your side.
C3 ENERGY INDICATOR WINDOW
See Figure 2.
The C3 energy Indicator window located on the side
of the handle, just above the base, will light when a
Diehard® 19.2 V llthlum-lon battery pack Is Installed and
has charge.
NOTE: Feature will not light with Craftsman 19.2 V nickel
cadmium battery packs.
C3 ENERGY
INDICATOR
WINDOW
LATCHES
DEPRESS LATCHES TO
RELEASE BATTERY PACK
Fig. 2