Craftsman 536.886260 - Manual (Page 4)

13. Never operate the snow thrower near en­
closures, automobiles, window wells,
drop-offs, and the like without proper ad­
justment of the snow discharge angle.
Keep children and pets away.
14. Do not overload the machine capacity by
attempting to clear snow at too fast a rate.
15. Never operate the machine at high trans­
port ^eeds on slippery surfaces. Look be­
hind and use care when backing up.
16. Never direct discharge at bystanders or
allow anyone in front of the unit.
17. Disengage power to the collector/impeller
when snow thrower is transported or not in
use.
18. Use only attachments and accessories ap­
proved by the manufacturer of the snow
thrower (such as tire chains, electric start
kits, ect.).
19. Never operate the snow thrower without
good visibility or light. Always be sure of
your footing and keep a firm hold on the
handles. Waik;never run.
20. Do not over-reach. Keep proper footing
and balance at all times.
21. Do not attempt to use snow thrower on a
roof.
MAINTENANCE AND STORAGE
1. Check shear bolts and other bolts at fre­
quent intervals for proper tightness to be
sure the equipment is in safe working
condition.
2. Never store the snow thrower with fuel in
the tank inside a building where ignition
sources are present such as hot water and
space heaters, clothes dryers, and the like.
Allow the engine (motor) to cool before
storing in any enclosure.
3. Always refer to operator’s guide instruc­
tions for important details if the snow
thrower is to be stored for an extended
period.
4. Maintain or replace safety and instruction
labels, as necessary.
5. Run the snow thrower a few minutes after
throwing snow to prevent freeze-up of the
auger/impeller.
A WARNING: This snow thrower is
for use on sidewalks, driveways
and other ground level surfaces.
Caution should be exercised while using on
steep sloping surfaces. DO NOT USE
SNOW THROWER ON SURFACES ABOVE
GROUND LEVEL such as roofs of resi­
dences, garages, porches or other such
structures or buildings.
IMPORTANT: Many of the following symbols are located on your unit or on literature sup­
plied with the product. Before you operate the unit, learn and understand the purpose for
each symbol.
Control And Operating Symbols
Slow
5
) ê
Fast Electric Start Engine Start Engine Run
O I hi H N
Engine Off Engine Stop On Choke Off Choke On Neutral
M
Throttle Primer Button Ignition Key
F-001088J 4
Ignition Off Ignition On