Craftsman 119.214000 User Manual
Page 4
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ASSEMBLY
1. TOOLS REQUIRED FOR ASSEMBLY
Item
Description
Q’ty.
’ Medium Screwdriver.....................1
Adjustable Wrench..........................1
Square............................................. 1
2. UNPACKING AND CHECKING CONTENTS
Model 119.214000 10” Bandsaw is shipped complete in
one box.
a. Separate all parts from carton and check each item with “Table
of Carton Contents” to make sure all items are accounted for,
before discarding any packing material.
b. Remove the protective oil that is applied to the table. Use any
ordinary house hold type grease and spot remover.
c. Apply a coat of paste wax to the table to prevent rust. Wipe all
parts thoroughly with a clean dry cloth.
CARTON CONTENTS
Item Description
Q’ty.
A
Main Machine..........................................................
1
B
Fence Assembly....................................................
1
C
Table........................................................................
1
D
Guide Rail...............................................................
1
E
Owner’s Manual.....................................................1
F
Upper Table Trunnion Assembly.........................1
G
Bag of Loose Parts............................................... 1
LIST OF LOOSE PARTS IN BAG
Item
Description
Q’ty.
•*
Blade Tension Knob.,
Miter Gauge..
O
Hex. Socket Head Cap Screw M6x30.......1
Washer 6..
Wing Nut M6..
Hex. BoltM6x12..........................................4
Lock Washer 6........................................... 4
w-
o
star Knob Screw..
Washer 6.
M3 Hex “L” Wrench..
M5 Hex “L” Wrench..
2. INITIAL ASSEMBLY
The machine is supplied partly assembled. Prior to use, the
following items have to be installed: Table, Blade Tension Knob
and Rip Fence.
WARNING:
To Avoid injury, do not attempt to run or use this
machine until all parts are assembled and working properly.
a. Assemble the upper table trunnion to the lower table trunion with
Carriage Bolt, Glide Piece, Washer and Wing Nut. Place the table
on to the upper table trunnion, taking care when passing the saw
blade through the slot of the table (See Fig. 1).
Locate four hex bolts and four lock washers from the bag of loose
parts. Mount the table to the upper table trunnion and install a bolt
with washer in each hole, then tighten with adjustable wrench.