Craftsman 119.214000 User Manual

Page 9

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

TROUBLESHOOTING

Problem

Diagnosis

Remedy

The machine does not work when

switched on.

1. No power supply.

2. Defective switch.
3 Defective motor.

1. Check the cable for breakage.
2. Replace the lock switch.
3. Defective motor.

The saw blade does not move with the

motor running.

1. The blade tension knob has not been

tightened.
2. The blade has come off one of the

wheels.

3. The saw blade has broken.

4. The drive belt has snapped.

1. Switch off the motor, tighten the blade

tension knob.

2. Open the doors and check.

3. Replace the blade.
4. Replace the belt.

The saw blade does not cut in a straight

line.

1. Rip fence for cutting not used.

2. Feed rate too fast.

3. The blade teeth are dull or damaged.
4. Blade guides not suitably adjusted.

1. Use a rip fence.

2. Put light pressure on the workpiece.
Make sure the saw blade does not bend.
3. Try a new saw blade.
4. Adjust the biade guides (see ADJUST­
MENT instructions).

The saw blade does not cut, or cuts very
slowly.

1. The teeth are dull, caused by cutting
hard material or long use.

2. The saw blade was fitted the wrong
way on the bandsaw.

1. Replace the saw blade, use a 6 T.P.I.

saw blade for wood and soft material.
Use a 14 T.P.I. saw blade for harder
materials. A 14 T.P.I. saw blade always
cuts slower due to the finer teeth and the
slower cutting performance.
2. Fit the saw blade correctly.

Sawdust builds up Inside the machine.

This is normal

Clean the machine regularly. Open the
doors and remove the sawdust with a

vacuum cleaner. -

Sawdust inside the motor housing.

This is normal

Clean the ventilating slots of the motor

with a vacuum cleaner. From time to time

remove the sawdust to prevent it from
being drawn into the housing.

The machine does not cut at 45 or 90
degrees.

1. The table is not at right angles to the

blade.
2. The saw blade is dull or too much

pressure was put on the workpiece.

1. Adjust the table.

2. Replace the saw blade or put less

pressure on the workpiece.

The saw blade can not be property

positioned on the wheels.

1. The wheels are not in alignment or
defective bearing.

2. The blade tracking knob hasn’t been

properly adjusted.
3. Inferior saw blade.

1. Replace bearing.

2. Adjust the blade tracking knob (See
ADJUSTMENT instructions).
3. Replace the saw blade.

ELECTRICAL SCHEMATIC

WAPfNING:

This machine must be grounded. To avoid electrocution or fire, any repairs to electrical system should be done only by a

rjuaiified electrician, using genuine replacement parts.

SWITCH

Advertising